Dating fender twin ii reverb amps


13-Dec-2016 14:37

dating fender twin ii reverb amps-12

irina 36 yo dating

465 designating the Oxford EIA code, 2 designating the year 1962, and 17 designating the 17th week of ’62.Take a look at this ’62 Fender Princeton Amp, and you’ll see that exact speaker, as well as the typical Schumacher transformers (EIA 606) used in Fender amplifiers.Contains the following capacitors, used as main filters, bias filter, and preamp cathode bypass capacitors: Fender Electrolytic Capacitor Kit 4A.Contains the following capacitors, used as main filters, bias filter, and preamp cathode bypass capacitors: Fender Electrolytic Capacitor Kit 5.With F&T capacitors, 70u F has been replaced with 80u F.On Ruby Gold capacitors in our standard kits, the polarity of the capacitor is indicated only by an arrow on the side of the capacitor which points toward the negative end.I use this before buying a amp always-check all four transformers-will tell you if there has been problems along the way. On the bottom lower corner of the grill cloth was/is a 1×2 inch “JBL” plastic logo that Fender attached.By 1968 deluxes usually left with CTS/EMINANCE speakers (Jensen had closed down) Once in awhile you can see the EIA code, CTS-starts with a #137-sometimes these are under the doughnut fender speaker label.

To give an example, a typical Oxford speaker from the ’60s will look something like: 465-217.Especially in the "silverface" years, the internal designs sometimes do not correspond with the schematic for the particular model version shown on the tube chart.



Nora previously worked as a TDR Matchmaker in New York, but she now lives and works in sunny Los Angeles.… continue reading »


Read more